Kohimarama SkyTV Dish Re-installation

A house under some renovation, SkyTV dish has to be re-installed in a more proper location.

The challenge of this installation is about the material where the dish stand mounted to. It is sand and cement mix, not concrete.

I have to use hammer drill to make a 6mm in diameter, 4cm deep hole until I can fell the timber, then use a timber lag screw to secure the mount.

The hole in the middle lower is through, there’s no timber inside after a 4cm deep drill. It is made up later on. 5 screws to secure the mount now.

Spread the word. Share this post!